Hi,
I'm not getting any response regarding this from other users, clarification not listed in manual or any tutorial.
I was reading through the manual to fully familiarize myself with WED, MED, SED etc. However, under
LoD Manager section of MED I found something strange. Following is the LoD Manager on my end:
But in the manual it says there should be
Mesh Reducer and
Recalculate in addition to
Delete Faces,
Delete LoD, and
Delete All which are available to me.
I experimented to see if certain conditions does make the other options appear, searched the forum, and searched Google etc. no result in any of them.
Just want whoever going to help me to know that I'm not asking even without trying to find it out by myself. ^^