hello everyone

i made a tank model

then i put the skin to the front

it seems good at front

but at both sides its too bad

i donot know how to put skin to the sides ??

so the tank has skin for front and another skin for right

can any one help please?

thanx

I assume you made a model in MED,
I think you set the skin type in MDL mapping type it has only two sides, back and front.
so you must set the skin to MD2 mapping skin type, it has left,right,bottom,top,front and back sides.

You can also use an UV-mapper.
like this: http://www.unwrap3d.com/ or http://www.uvmapper.com/