I add all of my 3d models in my world with the world editor. But when I try to compile the world and run and view the world I don't see my 3d models. I have the latest A6 Version which is 6.5. Is the reason for this is because it can't render high poly models at one time.

A realted problem

or you should set a higher camera.clip_far.


nipx

And check the normals of yours models. Maybe they have in opposite derction

i had this problem too. i my case it was because the models i added weren't from the work folder. but then i put them in my workfolder an everything was fine.
sam

Do you have to have a script to see the models when you compile and run your level?


I have tried the things like put your modes in the same work folder, but I will try again.

Have been doing a little testing and it seems when you display a high poly model on the screen it will not display. Does any body know anything about this?
Can somebdoy try this to see I am right about this issue.

Right now I believe it was that I didn't have one of my modeled textured. Could that be the case. I think that did it, but can somebody try that out for me. I will be happy if somebdoy tested it on their system. Thanks

no if a model is not skined the model shows up anyway.
sorry more i can't tell you.
sam

high poly... 3dgs has a maximum of triangles can display at the one time...
maybe (but I don't think so) your models have to much poly?
Second... try skinned it... just in some colour
Third... check the normals... sometimes when you import from 3ds the models have wrong normals and then they are invisible.
Try all this things and put your model to 3dgs and put a start position.

I think I had the wrong normals with a 3ds model. But overall I think it was that I didn't skin my model. thanks for the help...