Thanks for the feed back.... Hey towelie long time no speak. Not quite sure what you mean by the barrel being a bit small. Do you mean the diameter or the length?

Quote:

---

But doesnt it seem a bit big?

---

Lol now im really confused Im not sure it might be however I modeled it according to a picture... All I had was a side view so Im not positive as far as the width goes and had to go from memory... and its been awhile since Ive held a gun ... but from the side I think its pretty accurate.

Quote:

---

The revolver looks great, abit unsmoothen but I think if you would smootht it up more, the model wouldn't be low poly anymore

---

Not really all that low poly anyways I acctually added a few more faces because I ended up disconnecting the hammer so I could animate it and wanted to keep the mesh closed. I was aiming to keep it below 1000 polys but ended up just crossing over... I still might go in and optimize it a bit before I do the Uv map... Then on to the part I suck most at Skinning


Heres a pic against the refrence image I used... prehaps will say if its too big or not too big

Thanks for the feedback so far... Dont be shy and keep them coming