upload it to mediafire.com

Ok posted it ( I think )

I should show as rcarter123

and the file is "castle.wmp"


Um, just figured out how to post the file. lol

http://www.mediafire.com/?5e05ckf37d95dmz

Hey...
I downloaded your level and checked it out...
Can't run it with just the .wmp
(Would need a script, and it would work better if I had the missing Wads.)
I can build it though...
If you want to build in BSP mode... Or rather... not in simple mode...
Try this:
Select all your plates and go to "File/export/export as mdl file"
I suggest though that you turn on the "merge" toggle
Then export it...
Then add the model... And erase the original plates...
It will build in 1 sec in BSP mode....
I figure it is the Tesslation process in the build that's slowing you down...
If you waited longer, it would probably build...
Good Luck !

@TerraSame,
Doing that makes no sense, rather than doing that you can always build in simple mode. Because when you make whole level a single model, you lose all advantages of BSP.

@Sleepy, compile with standart lightmap resolution

Hey sleepy, I took what you gave us and I was able to compile it after I copied your level geometry into a new level, created a generic script, used the default textures and deleted the sera model reference. I can safely say there’s nothing wrong with the level geometry. It may be a problem with one of your textures. It's not uncommon I've even had a texture glitch once in A7 and it took me awile to find the corupt texture.

The manual says you'll get the out of memory error if one of you files is corrupt and I’m guessing that's what’s going on with you.

I could be wrong. just tossing out some ideas.


Manual:

Error E1004: Not enough memory (xxx MB required)
Error E1005: Out of memory

A Windows memory allocation (malloc or new function) failed. All today's PCs should have enough virtual memory (more than 2 GB), so you'll normally never see this error message. Check if your PC is misconfigured or set up to a very low virtual memory size. Another reason for this error message can be a too-high nexus value (exceeding the recommended limit) or a damaged model, sound or image file with a wrong internal size.

I realize that Quad... But apparently he didn't want to wait for the BSP build...

Nice work Tunisod... You had more time than me... I had to run off to the office...

And it looks like you raided the coffee pot!

I hope Sleepy has no more trubs...

It was the CGS blocks that was giving me a pain or one of them... Just deleted all the CGS blocks and started building with blocks..

Thanks for the help guys..

I've had problems like this too... All I do is just restart... It gets tiring doing it over and over again though. LOL.