Could anyone take a look at this post:

http://www.coniserver.net/ubb7/ubbthreads.php?ubb=showflat&Number=227121#Post227121

I really don't know why this error occurs ...

By the way ... the message shown is Error W1301, in the manual it is described as E1301.

Regards,
Pegamode

Yes, it's W1301 - that will be corrected in the manual. It means that the file is either not found, or it is found but can't be opened for some reason. This can happen f.i. when a model is in a subfolder that's not in the path.

The model is in a subfolder, but it's in the path.

The error occurs not everytime and when it occurs it's everytime another model. If I load the level ten times I sometimes get no error at all, and sometimes I get in 4 times out of the 10 the error W1301, but it's not everytime the same model that can't be loaded. The models that sometimes can't be loaded are set in WED.

A few minutes ago I checked it again and one time the whole wmb-file could not be loaded ?!?

Any more ideas?

Hmm, that could be a bug caused by something else in your project. Can you contact the support and send them the project? We'll look into this.

At current state the project is about 500mb ... I'll see if I could break it down a bit for a better share.